Prepar3d v2/v3 & Sbuilderx314 - Just a simple question.
Prepar3d v2/v3 & Sbuilderx314 - Just a simple question.
Luis, could you please tell us if is it possible to install and use the Sbuilderx314 with Prepar3d v2/v3 without have the FSX installed? A lot of people are racking their brains about that. Thanks (obrigado).
Re: Prepar3d v2/v3 & Sbuilderx314 - Just a simple question.
Of course, others Luis(es) and any other names can also answer.
- luisfeliztirado
- Posts: 436
- Joined: Sun May 15, 2005 9:15 am
- Location: Santo Domingo
Re: Prepar3d v2/v3 & Sbuilderx314 - Just a simple question.
Hello,
I do not have P3D, and so do not know anything more than what was posted in the thread just a few below this one (where you also posted.)
According to Dick and Mark, SBuilderX should work fine with the P3D tools. If you are blocked, try right-clicking on the SBuilderX icon and select "Run as Administrator".
Best regards.
Luis
I do not have P3D, and so do not know anything more than what was posted in the thread just a few below this one (where you also posted.)
According to Dick and Mark, SBuilderX should work fine with the P3D tools. If you are blocked, try right-clicking on the SBuilderX icon and select "Run as Administrator".
Best regards.
Luis
Re: Prepar3d v2/v3 & Sbuilderx314 - Just a simple question.
Wow, a greate one 'Luis' answered! It's a pleasure to talk to you, LuisFelizTirado. I do not have FSX anymore and when I try to point to Prepar3d at 'Full Path to Microsoft Simulator X' I do not have success because the path stays in red. I think Sbuilderx313 always asks for the FSX registry path. Cheers!