Page 1 of 1
Prepar3d v2/v3 & Sbuilderx314 - Just a simple question.
Posted: Tue Jan 26, 2016 12:54 pm
by Lacev
Luis, could you please tell us if is it possible to install and use the Sbuilderx314 with Prepar3d v2/v3 without have the FSX installed? A lot of people are racking their brains about that. Thanks (obrigado).
Re: Prepar3d v2/v3 & Sbuilderx314 - Just a simple question.
Posted: Wed Jan 27, 2016 2:22 pm
by Lacev
Of course, others Luis(es) and any other names can also answer.
Re: Prepar3d v2/v3 & Sbuilderx314 - Just a simple question.
Posted: Thu Jan 28, 2016 3:07 am
by luisfeliztirado
Hello,
I do not have P3D, and so do not know anything more than what was posted in the thread just a few below this one (where you also posted.)
According to Dick and Mark, SBuilderX should work fine with the P3D tools. If you are blocked, try right-clicking on the SBuilderX icon and select "Run as Administrator".
Best regards.
Luis
Re: Prepar3d v2/v3 & Sbuilderx314 - Just a simple question.
Posted: Sat Jan 30, 2016 11:34 pm
by Lacev
Wow, a greate one 'Luis' answered! It's a pleasure to talk to you, LuisFelizTirado. I do not have FSX anymore and when I try to point to Prepar3d at 'Full Path to Microsoft Simulator X' I do not have success because the path stays in red. I think Sbuilderx313 always asks for the FSX registry path. Cheers!