add map from disk

This is the Forum to discuss the use of SBuilderX (version 3.10 and above). For previous versions of SBuilder please use the "SBuilder for Flight Simulator FS2004" forum.
Post Reply
jyarddog
Posts: 67
Joined: Mon May 18, 2009 3:19 am

add map from disk

Post by jyarddog » Fri May 30, 2014 3:11 am

After doing so I get the calibrate message, but even after that I can't seem to get to the screen where I draw my red rectangle. If that is not available then how do I change the LOD so the photoreal shows up. Right now even with blendmask all I get for file size is 75 or somewhat higher. Photoreal does not show. Bob

Post Reply